Evercoat Dura-Build Acrylic Primer Surfacer - Gray, 2274 ,  1 Gallon - Jerzyautopaint.com

Evercoat Dura-Build Acrylic Primer Surfacer - Gray, 2274 , 1 Gallon

  • $149.00


A high build acrylic primer surfacer that easily fills grind marks, sand scratches and other minor surface imperfections. Sands easily to an ultra-fine finish with minimal shrinkage. Can be applied to properly prepared metal, body filler, polyester glazing putty, wood, fiberglass and aged sanded OEM topcoats.

SUBSTRATES

  • Properly Prepared Steel, Galvanized and Aluminum
  • Fiberglass
  • SMC
  • Rigid Plastics
  • Body Filler or Putty
  • Epoxy Primer
  • Self-Etch Primer

NOTE: For best adhesion and corrosion resistance, treat all bare metal areas larger than a quarter in diameter with a self-etch primer prior to application.

CLEANING

  • Surface must be clean and free of dirt, oil, grease and wax
  • Solvent clean all areas to be coated with a quality wax and grease remover and wipe dry with a clean, dry cloth
  • To solvent clean raw, exposed fiberglass, it is recommended to clean exposed area with acetone.

PREPARATION

Untreated Steel, Galvanized Steel and Bare Aluminum

  • Sand surface with 180 - 220 grit sandpaper. Blow off the surface with an air blow gun and solvent clean all areas to be coated with a quality wax and grease remover and wipe dry with a clean, dry cloth.
  • Follow paint company’s recommendations for surface prep and recoat of self-etch primer

Pre-Painted Surfaces

  • Sand repair area and featheredge using 80, 180, 220 and finish with 320 grit sandpaper on a random orbital sander.
  • Final clean with a quality wax and grease remover to remove sanding residue before priming.Sand repair area and featheredge using 180 grit, 220 grit and finish with 320 grit sandpaper on a random orbital sander
  • Final clean with a quality wax and grease remover to remove sanding residue prior to application

Body Filler or Putty

  • Finish sanding body filler or putty with 180-220 grit sandpaper
  • Featheredge with 320 grit sandpaper
  • Blow off the surface with an air blow gun

MIXING

  • Shake and stir thoroughly before mixing
  • Reduce 125% with #2296 Universal Zero VOC Reducer
  • Mix thoroughly before pouring primer into the gun cup

APPLICATION

  • Use a primer gun with a 1.4 to 1.8 fluid nozzle/air cap (Spray at paint gun manufacturer’s recommended air pressure)
  • Apply 2-3 medium wet coats allowing 5-10 minutes flash time between coats
  • FINISH
  • Ready to sand in about 60 minutes depending on film build
  • Once dry, sand with 400-600 grit sandpaper prior to next step

FINISH

  • Ready to sand in about 60 minutes depending on film build
  • Once dry, sand with 400-600 grit sandpaper prior to next step

 

Product# 2274 102274

 


We Also Recommend